After removing the screws on the front lenses I just removed the bulb socket with a twist.
If your lens is stuck put a small screw driver in the hole and wiggle it out easily!

Remember to use wet sanding paper or sanding pads or blocks. Sand in opposite directions often.

I sand by feel, when it seems smooth I wipe dry and check to make sure there are no scratches.
If there are I continue till it looks smooth or hazy as in the third picture above.

When you get to the 12000 grit paper you are going to think you can't get it any shinier!
Get some good plastic polish and buff for at least 2-3 minutes and you will see them glow!
You can see the difference it makes in the last picture. You might want to clean around the opening
before reinstalling the lens. You know the polish that used to stick on your lenses!

When done!
Go jump into the drivers seat and go for a ride.

Past Workshops covered