Pull the bottom of the door out and lift when all screws and studs are removed.
Make sure you only add a drop of oil to the top of the guides or it will run out the drain holes and onto your sill plates!
Run the window up and down a few times to spread the new
grease around.
Don't forget to reconnect all the electrical connectors!
Press the plastic back against the inside of the door and seal
as well as you can.
(P.S. do not get the black sealer on your hands or clothes as it is really
hard to remove!)
When replacing the door panel make sure everything lines up and gaskets are not pinched or distorted.
Pop the bottom of the door into the corresponding holes and replace screws and push pins.
Now jump into the drivers seat and go for a ride.
